mda_stereo
no way to compare when less than two revisions
Differences
This shows you the differences between two versions of the page.
Last revision | |||
— | mda_stereo [2022/07/26 17:19] – created shane | ||
---|---|---|---|
Line 1: | Line 1: | ||
+ | ====== mda Stereo ====== | ||
+ | **mda Stereo** adds artificial width to a mono signal. | ||
+ | This plug converts a mono signal to a " | ||
+ | - **Comb filtering** where the signal is panned left and right alternately with increasing frequency | ||
+ | - **Haas panning** where a time delayed signal sounds appears to be at the same level as a quieter non-delayed version. | ||
+ | |||
+ | Comb mode is mono compatible. Haas mode is not, but sounds fine on some signals such as backing vocals. This plug-in must be used in a stereo channel or bus. | ||
+ | |||
+ | ===== Parameters ===== | ||
+ | ^Width | ||
+ | ^Delay | ||
+ | ^Balance | ||
+ | ^Mod | Amount of delay modulation (defaults to OFF to reduce processor usage) | ||
+ | ^Rate | Modulation rate (note that modulation completely disappears in mono) | |
mda_stereo.txt · Last modified: 2023/05/08 18:59 by 127.0.0.1